Commercial Metal Stud Framing Columbus Ohio
Family-Owned & Operated | Premium Results | Fully Insured
Commercial Services Columbus Ohio
Metal stud framing is the backbone of commercial construction. We frame partition walls, fire-rated assemblies, soffits, and structural buildouts for tenant improvements, renovations, and new construction across Columbus and Central Ohio. Walls framed straight, plumb, and square, coordinated with MEP trades and ready for drywall.
Commercial Metal Stud Framing
We handle interior metal stud framing for offices, retail, restaurants, medical facilities, and industrial spaces. Load-bearing and non-load-bearing walls, fire-rated assemblies, headers, backing, and blocking. Framing done right makes every trade that follows easier. We coordinate with electrical, plumbing, and HVAC to make sure the walls are built to accommodate what goes inside them.
Our Services
Our commercial metal stud framing services include:
Interior and exterior metal stud wall framing
Load-bearing and non-load-bearing wall systems
Suspended ceilings, soffits, and partition walls
Blueprint reading, layout, and structural alignment
Installation of headers, backing, bracing, and fire-rated assemblies
Coordination with electricians, plumbers, and other trades
Fast, efficient installation with a clean, organized job site
Our Process
Commercial framing moves fast when it’s planned right. Layout, material staging, and trade coordination keep the job on schedule. Here’s how we run a metal stud framing project.
Layout & Planning
We start with the prints and verify dimensions on-site. Control lines get snapped, and we lay out wall locations, door openings, and any special conditions like fire-rated walls or structural headers. Any conflicts with existing conditions or MEP routing get flagged before framing starts. The goal is to catch problems on paper, not after the studs are up.
Track & Stud Installation
Floor and ceiling track go down first, fastened to the substrate per spec. Then studs get cut and installed at the layout marks, typically 16" or 24" on center depending on the assembly. We check for plumb as we go and brace where needed. Door and window openings get framed with proper headers and cripples. Everything stays square and aligned so drywall goes on flat.
Backing, Blocking & Handoff
Once walls are up, we install backing for fixtures, cabinetry, grab bars, and anything else that needs solid support behind the drywall. Fire-rated assemblies get the required blocking and firestopping. We coordinate with MEP trades to make sure everything is roughed in before closing up walls. When framing is complete, we walk the job and hand off to drywall with walls ready to hang.
Related Services
Framing is one part of the full drywall package. We also handle board hanging and finishing if your project needs the complete scope.
One crew from layout to final coat keeps the work consistent.
Commercial Drywall Hanging
Boards hung tight, flat, and ready for finish. We handle commercial drywall for tenant improvements, renovations, and new construction.
Commercial Drywall Finishing
Level 1 through Level 5 finishes and drywall texturing for commercial spaces. Tape, mud, texture, and skim coating. Walls finished smooth and ready for paint.